OpenBVE 1.5 on mac

View previous topic View next topic Go down

solved OpenBVE 1.5 on mac

Post by Richard2407 on Wed Feb 01, 2017 12:31 pm

Hi everyone. I have been using OpenBVE on and off for a few years now and it just gets better and better.

However I have come unstuck with 1.5 RC9 the version for mac.

I have a Macbook pro retina and I know it runs OpenBVE just fine.

Previously I have run the programme by opening the terminal writing mono and then dragging the .exe over to the terminal.
I have downloaded the 1.5 version from openbve-project site accessed via celtictrainsim.
It extracts ok and I drag the extracted programme to my applications folder. OK

Now this is where I fall down. I have not been able to work out exactly how to run the programme. I have had it running but in a very random and haphazard manner, I just kept pressing buttons until it started. ( and very good to is too. )
However when I go back to the programme after shutting down nothing will induce it to run again.

Mono is installed. The right one, don't know but it is 4.6 service release 2

Help appreciated

Regards

Richard

Richard2407

Posts : 12
Join date : 2017-02-01

Back to top Go down

solved Re: OpenBVE 1.5 on mac

Post by Richard2407 on Wed Feb 01, 2017 1:18 pm

OK I have found the answer. It now loads up in the blink of an eye.

It's all about pressing the right buttons.................

Regards

Richard

Richard2407

Posts : 12
Join date : 2017-02-01

Back to top Go down

View previous topic View next topic Back to top


 
Permissions in this forum:
You cannot reply to topics in this forum